This is a replacement lid for the Bobcat 300 miner. Pretty long print time. Use a brim or skirt to prevent warpage. Print Time: 8 hrs...

This is a wall mount for the SenseCAP M1 miner. Super low profile. Makes it look like it is floating. Print Time: 1 hr for both pieces...

If you were as annoyed by the screws on the edges of the miner that kept it from sitting flush, this one is for you. Don't forget it...

This is a mount I modeled up that will work with the RAK Wireless fiberglass antennas. It can be fastened directly on your patio fence...

This is just a little something to rep the project. Print Time: 1 hour 39 minutes. Slicing Software: Prusa Slic3r 3D Printer: AnyCubic i3...

This jig will help guide you when drilling holes on your pole/mast. This model will fit poles with an outside diameter of 1.75". It will...

This is a simple part for when you need to tighten the SMA connector to the back of the miner. In my case I used it to tighten the coax...

Happy HNT mining everyone! If you found the site helpful, please donate. Anything helps and goes towards supporting the page. Thank you.