This is a mount I modeled up that will work with the RAK Wireless fiberglass antennas. It can be fastened directly on your patio fence...

This is just a little something to rep the project. Print Time: 1 hour 39 minutes. Slicing Software: Prusa Slic3r 3D Printer: AnyCubic i3...

This jig will help guide you when drilling holes on your pole/mast. This model will fit poles with an outside diameter of 1.75". It will...

This is a simple part for when you need to tighten the SMA connector to the back of the miner. In my case I used it to tighten the coax...

Happy HNT mining everyone! If you found the site helpful, please donate. Anything helps and goes towards supporting the page. Thank you.